SINGER SEQS-6700 FUTURA QUARTET Instruction Manual - Manual (Page 62)

60
CORDING FOOT
Sew over one, two or three standards of cord to embellish
IDEULFV 3HDUO FRWWRQ HPEURLGHU\ ÀRVV RU ¿QH ZRRO \DUQ FDQ EH
used for cording.
Single cording
1. Mark the design on the fabric. Insert the cord in the center
groove of the cording foot from the right side opening. Pull
the cord about 5cm (2 inches) behind the foot.
2. The grooves of the foot will hold the length of the cord in
place while the stitches are being formed over the cord.
3. Select the stitch and adjust the stitch width so that the
stitches are just covering the cord. Lower the foot and sew
slowly, guiding the cord over the design.
Triple cording
1. Push the sewing thread to the left and insert three cords
into the grooves of the foot and pull out 5cm (2 inches) of
the cords behind the foot. Select the desired pattern and
adjust the stitch width so that the stitches are just covering
the cords. Lower the foot and sew slowly guiding the cords.
* The cording foot is an optional accessory.
* The cording foot is an optional accessory.
03
07 10