SINGER SEQS-6700 FUTURA QUARTET Instruction Manual - Manual (Page 45)

43
Reverse stitch button
Forward stitch button
Start/stop button
(For embroidery only)
LED indicator
FUNCTION BUTTONS WHEN
EMBROIDERING
OPERATION SWITCHES
LED INDICATOR
¿ Green light indicates machine is ready to start.
¿ Red light indicates machine is operating.
¿ Flashing red light indicates a problem or an error.
* Flashing for 2 - 3 seconds shows that an incorrect
operation was made.
* C o n t i n u o u s f l a s h i n g i n d i c a t e s t h a t t h e m a c h i n e
malfunctioned or is malfunctioning.
When start/stop button is pushed, machines starts slowly. To
stop the machine, push the button again and the machine will
stop sewing and the needle automatically stops at its highest
position.
FORWARD STITCH BUTTON
After the embroidery design has been transferred to the
machine, the embroidery can be advanced one stitch at a
time. Note: The embroidery hoop will move as it is advancing
through the design.
To advance continuously, press and hold this button.
REVERSE STITCH BUTTON
To back up through a design that is already in progress,
press the Reverse Stitch button. Pressing the button once will
reverse one stitch at a time. To reverse continuously, press
and hold this button. Design may be reversed all the way back
WR WKH ¿UVW VWLWFK RI WKH GHVLJQ
START/STOP BUTTON
THREAD TENSION CONTROL
Thread tension is automatically set at “E” for embroidery,
when the embroidery unit is attached.
You may wish to re-adjust thread tension according to the type
of fabric and thread being used.
NOTE: When sewing designs created by the software for
Photo Stitch (optional) it is recommended to decrease
the thread tension toward “0” and activate the Speed
Limiter, by checking the box in Machine navigator, before
sending the design to the machine. This ensures the best
performance of the machine.
Press Thread Cutter to automatically cut the top and bobbin
threads whenever the machine is stopped.
If Thread Cutting Mode is active (see page 14), the machine
will automatically cut the top and bobbin thread every time the
machine stops at the end of a color block.
Use auto thread cut only when changing thread colors.
THREAD CUTTER
Thread Cutter
Decrease tension Increase tension