Vinten Radamec SP-2000 Pedestal - Manual (Page 48)

SP-2000/X-Y Installation
3-8 User Manual
7. Switch the Local/Remote switch on the MCB controller to Local. Set the
Rotate switch on the MCB controller to Drive (switch handle pointing
towards the joystick) and check to make sure that the direction indicator for
each wheel is pointing forwards/backwards (in line with the ramp).
8. Gently pull back on the joystick to drive the pedestal towards the ramp.
Push the joystick left or right as needed to keep the pedestal centered on the
ramp.
9. Slowly drive the pedestal down the ramp and onto the studio floor. Note:
Even with the cable skirts raised, they may hang up on the top and bottom
of the ramp. If this happens, have an assistant pull up slightly on the pedes-
tal so that the skirt will clear.
AC Powered Unloading
1. Connect the Power/Data Cable from the power supply Power/Data Out
connector to the Power/Data In connector on the pedestal. If the power sup-
ply is not yet mounted in the rack, you can place it close to the crate for
convenience.
2. Temporarily install the E-STOP jumper plug (normally installed on the last
E-STOP box in the loop) into the E-STOP LOOP connector on the power
supply.
3. Connect the power supply AC cord and turn on the power supply.
Direction
Indicators
Hidden