Vinten Radamec SP-2000 Pedestal - Manual (Page 77)

SP-2000/X-Y Maintenance And Repair
User Manual 4-11
The East Wheel Cover
1. Use a 3/16” hex key to remove the direction indicator for the East wheel.
2. Use a 1/4” hex key to remove the screw in the side of the East wheel cover.
3. Use a 5/16” hex key to remove the two screws in the top of the East cover.
4. Have an assistant close by to disconnect the E-Stop switch harness and
bumper sensor harness. Carefully lift the cover up and off a few inches, dis-
connect the E-Stop harness connector and the bumper sensor connector
5. Remove the cover.
Direction Indicator
(3/16” hex)
Screws (5/16” hex) (1/4” hex)
Screw on the side