Vinten Radamec Control (VRC) - Manual (Page 74)

Configuration
73
Camera control
Fig. 38 Configuration screen - Camera Control options
Option ON OFF
Deselect A camera that has been
selected can be deselected
by touching it on the screen. A camera can only be
deselected by selecting a
different camera.
Always Take
Rudely Selecting a camera at one
controller immediately takes
control away from a second
controller that may have
been using the camera. A dialog appears requesting
you to confirm that you want
to take control of the camera
from the other controller.
Always Stop Fast For a pedestal that is in
motion during a Cut or Fade
between shots, selecting
STOP on the touchscreen or
on the control panel will
immediately stop the
pedestal movement.
This abrupt change of
motion is not desirable for a
camera that is on air, but
does ensure an immediate
stop to avoid a collision.
The position of the pedestal
is remembered by the
control system, so that you
can Cut or Fade to another
shot without needing to
target the pedestal. For a pedestal that is in
motion during a Cut or Fade
between shots, selecting
STOP on the touchscreen or
on the control panel will
cause the pedestal to
decelerate and coast to a
stop.
This smooth change of
motion is desirable if the
camera is on air. However,
to avoid a collision, you must
take into account the
amount of pedestal travel
after selecting STOP.
The position of the pedestal
is remembered by the
control system so that you
can Cut or Fade to another
shot without needing to re-
target the pedestal.
Camera Control
Always
Take
Rudely
Always
Stop Fast
Deselect