Vinten Radamec Control (VRC) - Manual (Page 99)

VRC System User Guide
98
3. When the pedestal is correctly positioned touch Target to display the list of
available targets.
4. Select the relevant target from the list and touch OK. The SP-2000 pedestal
will reposition and align itself to the target. When the pedestal stops moving,
a pop-up window will confirm that targeting was completed successful.
RP2A pedestal
RP2A pedestals will automatically reference their target – manual targeting is not
required.
NOTE: If you have targets installed in multiple studios, make sure that you select
the correct target for the pedestal being targeted in the studio that you are
currently working in - for example, select Studio 1 : Target 1 to target
camera #1 in studio #1 or select Studio 2 : Target 1 to target camera #1 in
studio #2. Stored shows and shots can only be recalled correctly if you
use the same target that was used when the shows and shots were
created.
Fig. 66 SP-2000 pedestal targeting start position