Welch Allyn CardioPerfect Workstation Resting ECG Module - User Manual - Manual (Page 42)

CardioPerfect Workstation
Resting ECG Module - User Manual
DIR 80012333 Ver. E 42 / 54
8.5. Recorder Tab
In the Recorder tab, you can configure your Welch Allyn CardioPerfect recorder. You can only
access this tab when you have administrator rights or when the software security is switched off.
The Recorder tab contains the following options:
Model The recorder model that is used. Use the MDX4 option for a MD or
portable, use the MDXN1 for a Pro recorder.
Frequency The sampling frequency of the recorder (either 300, 600 or 1200
Hz).
Port The communication port of the PC to which the recorder is
connected. This can be a standard serial port, a CPCOM ISA, a
CPCOM PCI card, a CPCOM PCMCIA card, or a USB port.
When operating in a thin-client environment, the application
displays an additional option, called PerfectLink
™. This option
allows the use of the PRO recorder with a USB cable in thin client
environments. This only works with the PRO recorder; therefore,
the recorder type is automatically set as well.
Address If you use a CPCOM ISA card, enter the address here.
IRQ If you use a CPCOM ISA card, enter the IRQ here.
AC filter (Hz) The frequency that is filtered by the AC mains filter. This can be
either 50 or 60 Hz.
Recorder options
Display switch off message This option disables the display
of the message “Switch recorder
off” after a test has been completed. If a Welch Allyn
CardioPerfect Pro recorder with USB connection is used this
option should be off/unchecked. Make sure this option is checked
if a RS232 connection is used.
Battery options
Enable low battery warning This option is only available for the PRO (MDXN1) recorder. With
this option you can enable or disable the displaying of a low
battery warning in the monitor.
Warn at In this field you can specify the remaining battery time at which the
monitor should display the low battery warning.
8.6. Customize ecg.txt
You can customize the statements that are used in the Comment editor according to your own
preferences. Please refer to the Workstation manual for further instructions.