Welch Allyn CardioPerfect Workstation Resting ECG Module - User Manual - Manual (Page 49)

CardioPerfect Workstation
Resting ECG Module - User Manual
DIR 80012333 Ver. E 49 / 54
Configuring the Software
After you have installed the PCI CPCOM card you need to configure the Workstation software in
order to allow communication between the program and the PCI-CPCOM card.
To configure Welch Allyn CardioPerfect Workstation:
1. Start Welch Allyn CardioPerfect Workstation and log in as Administrator
2. In the File menu, click Settings, click ECG and click on the Recorder tab.
3. Set the Port setting to CPCOM-PCI.
4. Click OK to save your settings.
12.4. Install the PCMCIA CPCOM Card
(Portable or MD recorder only)
The use of a PCMCIA CPCOM card requires a free type II PCMCIA slot and is not supported on
Windows NT 4.
The installation of the PCI CPCOM card is relatively easy and can be done by following the
instructions below:
1. Insert the Card into the PC.
2. The operating system will ask you for a driver upon insertion of the card into one of the
PCMCIA slots.
For Windows: Select the driver file that is located on the Welch Allyn
CardioPerfect Workstation CD in the:
2000 / XP R:\Drivers\ CPCOM-PCMCIA\Win2000\
"R" stands for the drive letter of your CD_ROM drive.
Configuring the Software
After installing the card you need to configure the Workstation software in order to allow
communication between the program and the card.
To configure Welch Allyn CardioPerfect Workstation:
1. Start Welch Allyn CardioPerfect Workstation and log in as Administrator.
2. In the File menu, click Settings, click ECG and click on the Recorder tab.
3. Set the Port setting to CPCOM-PCMCIA.
4. Click on OK to save your settings.