Welch Allyn Image Capture System - User Manual User Manual
Page 15
Directions for Use
Chapter 2 Equipment Setup
7
Review Draft
Company Confidential
Aug 24, 2004
Figure 3. DV converter settings
3.
Connect the Canopus DV Converter IEEE 1394 cable into the IEEE 1394 port on the
computer. Plug the opposite end of the cable into the port on the DV converter box.
Connect the power cord to the DV converter, but do not plug into an outlet.
Figure 4. Computer cable connections
4.
To connect the DV Converter to the Video Colposcope, plug one end of the provided
S-Video Cable into a Video In connection on the DV Converter and the opposite end of
the cable to the Line A Video Out on the Video Colposcope Monitor. Verify that the
S-Video Cable from the Video Colposcope is connected to the Line A Video In on the
back of the Video Colposcope Monitor.
IEEE 1394 Cable
Notebook Computer
IEEE 1394 Cable to Notebook Computer
with IEEE 1394 card
DV Converter Front
IEEE 1394 Cable
to Desktop
Computer with
IEEE 1394 card
Desktop Computer