Welch Allyn Image Capture System - User Manual - Manual (Page 9)

1
1
Review Draft Company Confidential Aug 24, 2004
Introduction
This manual describes the setup, installation, and use of the Image Capture System for
Desktop Computers, REF 88801 and Image Capture System for Notebook Computers,
REF 88802.
Indications
The Welch Allyn Image Capture System is intended to capture, display, save, export, and
print images obtained from the Welch Allyn Video Colposcope. The images captured,
displayed, saved, exported, and printed from the Welch Allyn Image Capture System are
not intended for diagnostic purposes. The provider shall use the image on the colposcope
monitor for clinical diagnosis.
Unpacking Checklist - Image Capture System only
• Welch Allyn Image Capture Software
• Welch Allyn Image Capture Directions for Use Manual
• DV Converter
• IEEE 1394 Cable
• S-Video Cable
• RS-232 Serial Communications Cable (9-pin)
• IEEE 1394 PCI or PCMCIA Card (if purchased)
• Registration/Warranty Card
• Installation Waiver form
Minimum System Requirements
• Pentium/Celeron Family - 800 MHz
• 256MB RAM
• Available IEEE 1394 Port
• Available RS-232 Port (for communication with Video Colposcope buttons)
• 20GB Available Hard Drive Space for image storage
• CD ROM drive (for software installation)
• Monitor with 1024 x 768 Resolution, 256 Color Minimum
• Windows
®
2000 or Windows
®
XP Operating System
*Verify your system has a dedicated IEEE 1394 port and a dedicated RS-232 port. The
Image Capture System does not support interfaces that reside on a hub, docking station,
port replicator or adapter (such as a USB to RS-232 adapter).