Welch Allyn Image Capture System - User Manual - Manual (Page 20)

12 Chapter 2 Equipment Setup Welch Allyn Image Capture System
Review Draft Company Confidential Aug 24, 2004
1. Click Start > Run from the task bar.
2. Type dxdiag then click OK. The DirectX Diagnostic Tool is loaded. On the System
(default) tab, toward the bottom of the System Information section, is an item named
DirectX Version. Verify the value for this item is DirectX 8.1 or later.
If the version of DirectX is earlier than 8.1, then perform the following steps to install
DirectX 8.1 on the computer.
1. Load the Image Capture System CD into an available CD-ROM drive. If the installation
program initiates, select Cancel to shut it down.
2. Click Start > Run from the task bar.
3. Use the drive letter of the CD-ROM drive, assuming it is D:, type
D:\DirectX 8.1\Win2000 Runtime\DX81NTeng.exe and click OK. This will launch the
DirectX 8.1 installation program.
4. Click YES to continue with the installation and click YES to accept the license
agreement.
5. When the installation process is complete, click OK to restart the computer.