Installing the versarails slide assemblies, Installing the versarails slide assemblies -10 – Dell PowerVault 770N (Deskside NAS Appliance) User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installing the VersaRails Slide Assemblies
1
At the front of the гаек eabinet, plaee a VersaRails slide assembly so that its mounting-
braeket flange fits between the marks or tape (or numbered loeation) on the raek (see
Figure 1-6).
The four holes on the front of the mounting braeket should align with four of the
holes between the marks you made on the front vertieal rail.
2
Install two 10-32 x 0.5-ineh flange-head Phillips serews in the mounting flange’s top
hole and the third-from-top hole (see Figure 1-6).
3
At the baek of the eabinet, pull baek on the mounting-braeket flange until the
mounting holes align with their respeetive holes on the baek vertieal rail.
3
Install two 10-32 x 0.5-ineh flange-head Phillips serews in the baek mounting flange’s
top and third-from-top holes to seeure the slide assembly to the baek vertieal rail.
5
Repeat steps 1 through B for the slide assembly on the other side of the raek.
6
Ensure that the slide assemblies are mounted at the same position on the vertieal rails
on eaeh side of the raek.
Figure 1-6. Installing the VersaRails Rail Assemblies
1-10
I R a c k I n s t a l l a t i o n G u i d e