Dell PowerVault 770N (Deskside NAS Appliance) User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
/K CAUTION: Because of the size and weight of the system, never attempt to install
the system in the slide assemblies by yourself.
2
Lift the system into position.
Using a minimum of two persons, eaeh person should plaee one hand on the front-
bottom of the system and the other hand on the baek-bottom of the system.
3
Tilt the front of the system upward while aligning the baek shoulder serews on the
sides of the system with the baek slots on the slide assemblies (see Figure 1-13).
Figure 1-13. Installing the System in the Rack
Engage the baek shoulder serews in the slot just behind the green slide-release lateh,
followed by the middle and front shoulder serews.
Push the system inward on the slide assemblies until the yellow system-release lateh
elieks into plaee, loeking the slide to the system’s middle shoulder serew (see
Figure 1-13).
Pull up on the green slide-release latehes and push the system into the raek.
Tighten the thumbserews on the raek front panel.
1-16
I R a c k I n s t a l l a t i o n G u i d e