Hit Products RainPro Battery Operated Controller - Manual (Page 5)

4
Basic Controller Functions
This section gives a brief description of the Controller buttons.
See the following sections for further details.
MODE Button: Quick presses of the MODE button turns the
controller off, or turns on a specific program (P1, P2, P3).
Longer presses of the MODE button puts the Controller in the
programming mode.
SET Button: Press the SET button to set and advance functions.
+ -
Buttons: Use the plus/minus buttons to increase and decrease
schedule functions.
Installation
Turn off the water supply.
Install the valve in the irrigation system. Be sure the arrow on the
valve is pointing in the direction of the water flow. The solenoid
sleeve on back of the controller may be adjusted to ease installation.
Occasionally the valve opens in transit. To ensure that the valve is
closed before you open the water supply, first make sure that the
Controller is not set to OFF (If it is set to OFF, press briefly on the
MODE button and turn it on). Then press
+
and SET simultaneously
to open, and press
-
and SET simultaneously to close. You are now
ready to program the Controller.
Turn on the water supply.
1.
2.
3.
4.
Manual Operation
To manually open the valve, make sure that the Controller is not set to
OFF (If it is set to OFF, press briefly on the MODE button), then press
+ and SET simultaneously. This will open the valve.