Hit Products RainPro Battery Operated Controller - Manual (Page 9)

8
Setting the Irrigation Run Time
To set duration of all irrigations, you must be in an operating
mode (P1, P2, or P3).
1. Press the MODE button until the clock setting screen
appears, then press MODE again until the following
screen appears (the minutes will be flashing).
On this screen, the clock numbers refer to the amount of time
you wish irrigation to continue. Minimum time is 1 minute.
Maximum time is 11 hours 59 minutes in 1 minute increments.
2. Use the + and the
-
buttons to adjust the minutes.
3. Press SET to continue.
4. Use the + and the
-
buttons to adjust the hours.
5. Press SET to continue.