Cisco 700 MHz - Manual (Page 13)

1-3
Installation and Upgrade Guide for Cisco Unified MeetingPlace Audio Server 6.x
OL-13417-01
Chapter 1 Preparing to Install the Cisco Unified MeetingPlace 8100 Series Hardware
Hardware Requirements
Warning Blank faceplates and cover panels serve three important functions: they prevent exposure to
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place. Statement
1029
Warning Class 1 laser product. Statement 1008
Warning Do not stare into the beam or view it directly with optical instruments. Statement 1011
Warning Never install telephone jacks in wet locations unless the jack is specifically designed for
wet locations. Statement 1036
Warning Never touch uninsulated telephone wires or terminals unless the telephone line has been
disconnected at the network interface. Statement 1037
Warning Use caution when installing or modifying telephone lines. Statement 177
Warning This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Hardware Requirements
The Cisco Unified MeetingPlace Audio Server system requires a Cisco Unified MeetingPlace 8100
series server.
For a new Release 6.0 system, Cisco Unified MeetingPlace Audio Server software is installed in
manufacturing, so you do not need to install Audio Server software.
Note The Cisco Unified MeetingPlace Audio Server must be connected to a network switch port that is
configured for auto-negotiate. Cisco Unified MeetingPlace gateways must be connected to network
switch ports that are configured for 100/1000 MB Full Duplex.