Cisco 700 MHz - Manual (Page 73)

C H A P T E R
5-1
Installation and Upgrade Guide for Cisco Unified MeetingPlace Audio Server 6.x
OL-13417-01
5
Testing the Cisco Unified MeetingPlace Audio
Server System Installation and Upgrade
This chapter explains how to power up the Cisco Unified MeetingPlace Audio Server and how to test
the installation and upgrade. It contains the following sections:
• Powering Up the Cisco Unified MeetingPlace Audio Server System, page 5-1
• About Testing the Cisco Unified MeetingPlace Audio Server System Installation or Upgrade,
page 5-2
• Testing Inbound Calls for T1 CAS, T1 PRI, and E1 Telephony by Using Circular Hunting, page 5-3
• Testing Inbound Calls for T1 CAS, T1 PRI, and E1 Telephony by Using a Dialing Sequence,
page 5-4
• Testing Outbound Calls for T1 CAS, T1 PRI, and E1 Telephony, page 5-4
• Testing Scheduling, page 5-5
• Testing Conferencing in Recorded Meetings, page 5-6
• Testing Conferencing in Nonrecorded Meetings with Ad Hoc Recording, page 5-6
• Testing Cisco Unified MeetingPlace Web Conferencing, page 5-6
• Testing Network Latency, page 5-7
Powering Up the Cisco Unified MeetingPlace Audio Server
System
The Cisco Unified MeetingPlace Audio Server system can take 5 to 10 minutes to complete
initialization.
To Power Up the Cisco Unified MeetingPlace Audio Server System
Step 1 Move the Cisco Unified MeetingPlace Audio Server power switch to the on (“|”) position. Allow up to
10 minutes for the Audio Server system to initialize.
Step 2 Connect your laptop to Cisco Unified MeetingPlace to confirm that the Cisco Unified MeetingPlace
Audio Server has come up properly. (If your laptop has not been connected and set up, see the
“Connecting Your Laptop to Cisco Unified MeetingPlace” section on page 3-1 and the “About
Configuring Your Laptop” section on page 3-2 .)