Cisco 700 MHz - Manual (Page 35)

2-11
Installation and Upgrade Guide for Cisco Unified MeetingPlace Audio Server 6.x
OL-13417-01
Chapter 2 Installing the Cisco Unified MeetingPlace 8100 Series Hardware
Connecting the Cables to the Cisco Unified MeetingPlace 8100 Series
Connecting the Power Cable to the Cisco Unified MeetingPlace 8100 Series
Warning This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Warning When installing or replacing the unit, the ground connection must always be made first and
disconnected last. Statement 1046
To Connect the Power Cable to the Cisco Unified MeetingPlace 8100 Series
Step 1 Locate the power cable that shipped with the Cisco Unified MeetingPlace Audio Server.
Step 2 Attach the socket end of the power cable to the AC inlet on the back of the Cisco Unified MeetingPlace
Audio Server.
Step 3 Plug the other end of the power cable into the AC power source.
Connecting the SCSI Cable to the Cisco Unified MeetingPlace 8112
Note The Cisco Unified MeetingPlace 8106 does not have a SCSI cable.
To Connect the SCSI Cable to the Cisco Unified MeetingPlace 8112
Step 1 Confirm that the power switch on the Cisco Unified MeetingPlace 8112 is set to off (“O”).
Step 2 Attach one end of the SCSI cable that came with the Cisco Unified MeetingPlace Audio Server system
to the SCSI connector on the back of the floppy-drive housing.
Step 3 Attach the other end of the SCSI cable to the SCSI port on the CPU transition module in slot 7 on the
back of the Cisco Unified MeetingPlace 8112.
Connecting the LAN Cable to the Cisco Unified MeetingPlace 8100 Series
You must supply the LAN cable to connect the Cisco Unified MeetingPlace Audio Server to the network.
See the
“LAN Requirements for Cisco Unified MeetingPlace Systems” section on page 1-12 to confirm
that you have the correct LAN cable and connector.
To Connect the LAN Cable to the Cisco Unified MeetingPlace 8100 Series
Step 1 Locate the LAN cable.
Step 2 Plug one end of the LAN cable into the LAN socket.