Cisco 700 MHz User Manual
Page 74
5-2
Installation and Upgrade Guide for Cisco Unified MeetingPlace Audio Server 6.x
OL-13417-01
Chapter 5 Testing the Cisco Unified MeetingPlace Audio Server System Installation and Upgrade
About Testing the Cisco Unified MeetingPlace Audio Server System Installation or Upgrade
Step 3
If the Cisco Unified MeetingPlace Audio Server is not up, confirm that all components are secure:
a.
Confirm that all the cards are securely seated. (For the Cisco Unified MeetingPlace 8112, check if
any of the blue LED lights below the cards are on. If a blue light is on, the card or transition module
is not seated properly.)
b.
Turn the power switch to the off (“O”) position.
c.
Confirm that all the connections are secure.
d.
After confirming that all components are secure, repeat the power-up procedure. If the Cisco
Unified MeetingPlace Audio Server does not initialize properly on the second try, contact
Cisco TAC. (See the
“Obtaining Documentation, Obtaining Support, and Security Guidelines”
Step 4
At the Cisco Unified MeetingPlace prompt, enter your username and password. The default username is
admin, and the default password is cisco. The following menu appears:
user name: admin
Password:
Last login: Mon Aug 21 12:19:16 from Unknown-HostName
*******************************************************************
* MeetingPlace(tm) *
* by Cisco Systems *
* *
* Copyright (c) 1993-2006 Cisco Systems, Inc. *
* All rights reserved. *
*******************************************************************
Conference server 5.4.0 S/N: not set
Mon Aug 21 14:32:03 PST 2006
meetingplace:tech$
This allows you to enter commands on the Command Line Interface (CLI). For information about CLI
commands, refer to the “Command-Line Interface Reference” appendix of the Configuration Guide for
Cisco Unified MeetingPlace Audio Server at
Note
The Cisco Unified MeetingPlace system does not support DNS; therefore, the name of the server
that last logged in to the Cisco Unified MeetingPlace system is unknown.
About Testing the Cisco Unified MeetingPlace Audio Server
System Installation or Upgrade
To verify inbound calls, you must have a means for directly selecting each trunk connected to the Cisco
Unified MeetingPlace system. Most PBX and central office trunks either use circular hunting, which
accesses each port in turn, or allow each trunk to be selected with a special dialing sequence.
Note
To test IP telephony, see the “About Troubleshooting IP Ports That Do Not Answer” and “About
Troubleshooting IP Calls That Connect But No Audio is Heard” sections in the “Troubleshooting the
Cisco Unified MeetingPlace System Configuration” Chapter of the Configuration Guide for Cisco