Cisco 700 MHz User Manual
Page 75
5-3
Installation and Upgrade Guide for Cisco Unified MeetingPlace Audio Server 6.x
OL-13417-01
Chapter 5 Testing the Cisco Unified MeetingPlace Audio Server System Installation and Upgrade
Testing Inbound Calls for T1 CAS, T1 PRI, and E1 Telephony by Using Circular Hunting
Unified MeetingPlace Audio Server at
.
Testing Inbound Calls for T1 CAS, T1 PRI, and E1 Telephony by
Using Circular Hunting
To Test Inbound Calls for T1 CAS, T1 PRI, and E1 Telephony by Using Circular Hunting
Step 1
Access the CLI.
Tip
If you do not already have terminal logging turned on, turn it on before proceeding. For
information on logging, see the
“Logging Your HyperTerminal Session” section on page 3-3
Step 2
Enter spanstat span_number -all and press Enter. For the span number, start with span 0 and check each
port before moving onto span 1 and other active spans.
Step 3
Dial the system access number.
Step 4
Look at the spanstat command output to monitor which port receives the call. For example, in the
following code for T1 CAS, span 0, port 1 received the call.
meetingplace:tech$ spanstat 0 -ab
Span 0 (Card 0 Trunk 0) is up
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
TR TR TR TR TR TR TR TR TR TR TR TR TR TR TR TR TR TR TR TR TR TR TR TR
33 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
In the following code for T1 PRI, span 0, port 1 received the call.
meetingplace:tech$ spanstat 0 -ab
Span 0 (Card 0 Trunk 0) is up
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3
10 20
ii........ ......... ......... ......... .....
In the following code for E1, span 0, port 1 received the call.
meetingplace:tech$ spanstat 0 -all
E1 Span 0 (ETI 0 Line A) is up
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0
10 20 30
ii........ ......... ......... ......... ......... ...........
Note
Enter spanstat help to determine the character code definitions and sequences for the various
types of connections.