Wilbur Curtis TLP - Manual (Page 2)

2
ENTER THE PROGRAMMING MODE #1:
 Press for two seconds, then RELEASE.
 will start blinking. Each blink equals 2º F, starting at 170º (max.
temp. 206º F or 19 blinks).
 To change Temperature, press and HOLD .
 will start QUICK flashing. Each QUICK flash equals 2º F. After
reaching 206º, temperature starts over at 170º.
 RELEASE when the desired temperature is reached (new temp.
will now be displayed).
 To set and exit, press .
STEPS TO
PROGRAMMING
Your Curtis TLP system is factory pre‑set for optimum performance. Generally, there will not be a need to
change programming.
Changing the TLP Program
The TLP features a dynamic memory. In the event of a power loss, it will remember ALL program settings.
Brew Temperature – Factory Pre‑Set to 200°F
Function to set brew temperature, 170° to 206°F. Brew temperature will be indicated by READY‑TO‑BREW
light blinking.
CAUTION: These steps
involve working with
hot water. Avoid against
splashing and spilling.
CONFIRM/RESET BREW TEMPERATURE - Factory Preset
to 200ºF
For ALL functions you must first enter the programming
mode.
 Turn OFF the power from the Control Panel by press-
ing .
 Press and HOLD and press and RELEASE .
 Continue HOLDING until starts blinking; RE-
LEASE.
ENTERING THE PROGRAM MODE #1
Nº of
Blinks
1
2
3
4
5
6
7
8
9
10
Temp.
170º F
172º F
174º F
176º F
178º F
180º F
182º F
184º F
186º F
188º F
Nº of
Blinks
11
12
13
14
15
16
17
18
19
Temp.
190º F
192º F
194º F
196º F
198º F
200º F
202º F
204º F
206º F
Temperature Table