Wilbur Curtis GEM3IF - Manual (Page 3)

3
Display Timers
< - - Select - - >
The G3/Gold Cup Series Brewing System is Factory Pre-Set for Optimum Performance.
After connection to water and power; the rear toggle switch must be on. You will hear a beep sound, indicating power is available to the controller.
The control displays . Press ON/OFF button and the screen will display . After three seconds, is displayed.
Water will fill the tank (approximately 2-3 minutes depending on water flow rate). When the proper level is reached will appear on the
screen. It takes approximately 20 minutes to reach setpoint temperature of 200°F.
Control will display when temperature reaches the setpoint (200°F). Unit is now ready to brew.
<GEMINI TWIN>
WILBUR CURTIS
CURTIS CURTIS
FILLING
CURTIS
HEATING
CURTIS
READY
PROGRAM
MENUS
All programming selections are performed with the three center
buttons.
The symbols below the buttons are:
Scroll LEFT
¤ SELECTION or ENTER to save new parameter
Scroll RIGHT
IMPORTANT NOTE:
GEM INTELLIFRESH