Wilbur Curtis ILGD - Manual (Page 3)

3
PROGRAMMING THE ILGD GRINDER
Your grinder has been adjusted at the time of manufacture to provide satisfactory performance in most situations. In the
event that you would like to vary the settings the grinder can be reprogrammed. Both grinders are programmed identically.
1. Place a paper filter beneath the grinder spout to catch coffee as it is ground.
2. Turn off the unit at the front panel, ON/OFF button.
3. Press and hold one of the grind buttons.
4. Press and release the ON/OFF button. Continue holding the grind button.
5. In the red window, the grind time on the button pressed will appear. Continue
to hold and the time digits will start at 00 and increase. Release the button
to set the new time. The table (left)can be used as a guide to estimate the
amount of ground coffee you dispense with the chosen setting.
6. Wait for the motor to completely stop (10 seconds). To set and exit, press and
release any other grind button.
7. Repeat the above steps to reset any other grind button.
Time settings in this table are only approximate. Amounts will vary with grind texture and specific coffee bean. Weigh your output, then
make adjustments as necessary.
1.3
1.5
1.8
2.0
2.5
3.0
3.7 4
5
6
7
8
10
12
15
20
25
30
35
40
45 4.5
6.2
7.6
8.8
10.0
11.8
13.5
Seconds Ounces Seconds Ounces
TROUBLE- SHOOTING
GUIDE
POSSIBLE CAUSE SOLUTION
4. Shear disk may have broken. Change the shear disk (see page 2 for directions).
5. Funnel to grind housing may Cut off power to machine. Empty the hopper of beans.
be jammed. Clean where the hopper funnels into the grind housing.
POSSIBLE CAUSE SOLUTION
1. Circuit breaker may be tripped. Grinder has a circuit breaker behind machine. Push in reset
button. You should hear a “click”.
2. Electrical cord may not be Push plug into outlet.
making contact.
3. Electrical outlet may not With voltmeter, determine if there is power at outlet.
have power.
POSSIBLE CAUSE SOLUTION
6. Grinding burrs may be worn. Readjust the grind (see page 2).
7. Housing cover may not be on Pull off the cover and clean the mounting surfaces.
straight or not seating correctly. Reassemble the housing.
This appliance is
designed for com-
mercial use. Any
servicing other than
cleaning and maintenance
should be performed by an
authorized Wilbur Curtis ser-
vice center.
SYMPTOM: MOTOR RUNS BUT NO COFFEE COMES OUT
SYMPTOM: MOTOR DOES NOT RUN
SYMPTOM: GROUND COFFEE TEXTURE TOO COARSE OR POOR QUALITY