Wilbur Curtis SLG User Manual
Page 2
2
NOTE: Time settings in
this table are only ap-
proximate. Amounts will
vary with grind texture and specific
coffee bean. Weigh your output, then
make adjustments as necessary
ILLUSTRATED PARTS LIST
GRINDER MOTOR
SETTING TIMER ON SLG GRINDER
1. Take off timer cover (behind hopper) removing four screws. Locate timer.
2. Timer controls are one high/low switch, allowing you to select a scale on timer dial; outside scale range is .5 through
15, inside scale range is 2 to 60.
3. Test adjustment by grinding some coffee. When amount is satisfactory, reinstall timer cover.
CHANGING A BROKEN SHEAR DISK (CONTINUED)
7. Re-insert the feed worm and grinding burr on the motor shaft.
8. Push the shear drive through the burr/feed worm assembly and align the large slot with tongue on motor shaft.
9. Rotate the burr/feed worm assembly to align the slot with the narrow slot on shear drive.
10. Slip a new shear disk into the slot. Cover with the shear cap. Replace the grind cap and thumb screws.
11. Return power to the unit.
TIMER ADJUSTMENT
9
10
11
5
3
6
4
7
1
8
1
2
3
4
5
6
7
8
9
10
11
MOTOR CRUSHING GRINDER ASSY 120VAC
KIT, GRINDER CHUTE NEW STYLE
CAPACITOR, COFFEE GRINDER ASSY
SHEAR DRIVE COFFEE GRINDER
SHEAR DISK, 6 PCS
CAP, SHEAR DISK GRINDERS
COVER, GRINDER HOUSING W/LABEL
SCREW & THRUST PIN ADJUSTING ASSY
BURRS, SET CRUSH HIGH FLOW
SPRING, TENSION COFFEE GRINDER
WORM FEEDING ASSY CCG
WC-9135
WC-37284
WC-91026
WC-91024
WC-9107-6
WC-91016
WC-91017
WC-91015
WC-91045
WC-91021
WC-91020
INDEX
NUMBER
DESCRIPTION
PART
NUMBER
2