V.I.O. POV.1.5 - Manual (Page 10)

10
Powering and changing the Remote Control and I.D. Channel
The wireless remote control unit uses an A27 12 volt battery, which is included
with the unit and pre-installed.
If you need to replace the battery in the wireless remote control:
1 Place the remote unit on a flat surface with the buttons facing up.
2 Unscrew the four small Phillips screws in each corner and lift the cover from
the remote. Take care to protect the inside of the remote control unit from
dust and moisture while the cover is removed.
3 After changing the battery, replace the cover, tightening the four screws
uniformly to create even pressure against the seal.
Changing the Remote I.D. Channel - On the Remote Control
The REMOTE I.D. channel of the wireless remote control is set using a small rotary
dial located inside the remote control. To adjust the channel you will need to open the
remote control unit in the same fashion above.
1. Use a small flat blade screwdriver to carefully rotate the pointer to the desired
setting. Take care to protect the inner workings of the remote from dust and
moisture while the cover is removed
2. Replace the cover, tightening the four screws uniformly to create even
pressure against the seal
Changing the Remote I.D. Channel - On the POV.1.5
If you are using more than one POV.1.5 system at the same time you will need
to adjust the REMOTE I.D. channel that the wireless remote control uses to
communicate with the POV.1.5. The remote control and POV.1.5 must be set to the
same channel in order to work together.
The POV.1.5 and wireless remote control are shipped with both of their REMOTE
I.D.’s set to channel 0. There are a total of 10 available REMOTE I.D. channels that
you can use to allow multiple POV.1.5’s and their remote controls to be used in
close proximity without interference.
To change the REMOTE I.D. channel of the POV.1.5 Recorder:
1. Press the SETTINGS button
2. Press the PREV or NXT soft keys until REMOTE I.D. is shown in the display
and press SELECT
3. Press PREV or NXT until the desired channel is displayed and press the
SELECT soft key to choose that channel.
Remote with cover
removed. I.D. set
to 0