V.I.O. POV.1.5 - Manual (Page 15)

15
press TAG or REC/TAG.
Press the RECORD button to stop recording and switch the unit to Standby mode.
If you want to switch back to Clip recording mode you will need to go back to the
Settings menu.
The upper left corner of the display will show PLAY and the top center of the display will
indicate the number of the current clip and total number of saved clips. For example,
33/33 means you are looking at clip number 33 out of a total of 33 clips, and 1/33
would mean that you are looking at clip number 1 of 33.
Working with SDHC Memory Cards
The POV.1.5 records video to SDHC memory cards. You can use cards as large as
8GB. V.I.O. recommends using SDHC cards with a class 4 rating or higher. Before
you can record video to an SDHC card it must be formatted by the POV.1.5.
To format an SDHC card:
1. Remove the Input/Output Port cover at the bottom of the POV.1.5
2. Insert the card into the SDHC slot face up; the end of the SDHC card with
the small notch should be inserted into the slot
3. Press the SETTINGS button, and repeatedly press the NXT soft key until
Format SD Card is shown in the display
4. Press the SELECT soft key to highlight the default choice, which is NO.
Press the NXT soft key until YES is shown in the display, then press
SELECT again to format the card
IMPORTANT: Formatting an SDHC card erases everything on the SDHC card.
Tip If you are doing a lot of recording you will probably want to have several
SDHC cards already formatted and ready to use. You may also want to consider
using a memory card reader that attaches to your PC or Mac to back-up files
from your SDHC cards. You can then take the cards out of the POV.1.5 and place
them in the memory card reader where they will appear as storage devices (disk
drives).