V.I.O. POV.1.5 - Manual (Page 7)

7
Installing the SDHC Card
To install the SDHC card you need to remove the Input/Output Port cover located
at the bottom of the POV.1.5.
The Input/Output Port cover is attached to the bottom of the POV.1.5 with a
retaining screw. In order to keep the POV.1.5 water-resistant the Input/Output
Port cover fits very tightly, and thus it may appear to be difficult to remove.
Note: Please use a small coin or nail to pry it open. Be careful to pry the
cover open gently so as not to damage the cover or its water-resistant
seal.
Note: When the retaining screw is fully unscrewed it will be loose, but will not
come completely out of its socket
Once the Input/Output Port cover is removed, insert the SDHC memory card in the
slot. You should insert the SDHC card oriented so that the label is facing towards
you and the small notch is in the right top corner - the notched end of the SDHC
card is the one you insert into the slot. When the card is fully inserted it will click
into place.
Replace the Input/Output Port cover and screw the retaining screw clockwise until
it is tight.
Your POV.1.5 is now ready for use.
The Input/Output Port
cover is located on the
bottom of the POV.1.5
The bottom of the POV.1.5 with
the SD card inserted