V.I.O. POV.1.5 User Manual
Page 6
6
Installing the Batteries
To install the batteries start by turning the POV.1.5 unit over and place it face
down on a flat clean surface to avoid scratching the screen.
Back of the POV.1.5
Back of the POV.1.5 with the battery
compartment cover removed.
Pull the tabs on each side. Do not force them
down any further than necessary, the tabs only
need to be opened as far as is shown in the
photo to the left
Now, remove the battery compartment
cover from between the tabs. You can lift
the cover by grasping it at the top and
bottom and pulling straight up, or you
can pry it gently using your fingernail or
a small screwdriver. Note that the tabs
remain attached to the POV.1.5 when you
lift the cover off. Install 4 AA batteries
according to the diagram embossed into
the bottom of the battery compartment.
Replace battery cover and push the tabs
back into place.