BendixKing SG 465 System EFS 40/50 - Manual (Page 88)

MFD Operation
81 must have the graphic output
b u s .
With an LNAV, RNAV, (or KNS
81 configured as a NAV) select-
ed for the primary nav sensor
and during display of a NAV MAP
on the MFD, initial movement of
the joystick will create a waypoint
cursor ahead of the aircraft on
the half range ring at the current
heading. This will be true for both
HSI and ARC display formats.
The cursor will be a standard
white waypoint symbol. Move-
ment of the waypoint will be in
any of the eight directions com-
manded by the joystick. The rate
of movement will start off slow
and increase in speed in two
steps. Return of the joystick to
its center, off position at any time
will reset the rate of movement to
the slowest speed. The cursor
location on the display screen
and its rate of movement relative
to the display screen will be inde-
pendent of the display range
selected. The cursor is not
allowed to exit the compass.
When an LNAV is selected as
the primary navigation source,
Lat/Lon coordinates of the cursor
will be displayed in the lower cen-
ter of the display. When a KNS
81 is the active primary naviga-
tion source, and it is not in the
ILS mode, radial and distance of
the cursor from the navaid in use
by the KNS 81 will be displayed
instead of Lat/Lon coordinates.
The cursor position information
can be transferred to the LNAV
or KNS 81 that is selected as the
primary navigation sensor, by
pressing the ENTER button while
the cursor and its coordinates are
displayed. The coordinates of the
cursor will remain displayed for at
least 10 seconds and disappear
from the display within 15 sec-
onds after activating the ENTER
button. If the waypoint cursor is
not moved for 20 seconds, it will
disappear from view. The next
time the joystick is moved, the
cursor will re-appear in the same
location on the display screen.
However, a change of primary
NAV sensor or display modes will
reset the invisible cursor location
to its initial starting position.
Note: Systems with an MFD can
have the joystick on the CP
469A MFD control panel or a
stand alone joystick. Additional
joysticks for the pilot or copilot
normally will not be installed.
Systems without an MFD may
have up to two joysticks that
are completely independent of
each other; one for the pilot
and one for the copilot. The
pilot
’ s joystick can create or
move a waypoint only on the
pilot
’ s EHSI, and any waypoint
created by the pilot can only
be loaded into the #1 RNAV or
#1 LNAV. Likewise, the copi -
lot
’ s joystick can create or
move a waypoint only on the
copilot
’ s EHSI, and any way -
point created by the copilot
can only be loaded into the #2
RNAV or #2 LNAV.
w
PLAN VIEW OPERATION
(available with 07 and higher)
Plan View will be available in the
HSI key selection sequence
2.4.4 Issued 8/10 SW 04/05/06/07/08/09/10/11/12/13/14/15/16
Section 2.4mp 9/8/10 7:49 PM Page 2.4.4