CANOGA PERKINS 9135 SNMP Managed 10/100/1000 Ethernet Switch - Manual (Page 11)

EdgeAccess Universal Chassis System
Model 9135 10/100/1000 2-1
Chapter 2
Setup and Installation
This section describes how to install the 9135 and the interface modules.
Caution Equipment intended only for installation in a RESTRICTED ACCESS LOCATION
accessible only to electrically skilled persons and electrically instructed persons with
the proper authorization.
2.1 Install the 9135
The 9135 is tested and inspected before shipment from the factory. If there is obvious damage to the
shipping container, contact the carrier immediately.
Caution: Follow electrostatic discharge (ESD) safety precautions when handling Canoga
Perkins products, as with all electronic devices with static sensitive components.
1. Unpack the 9135. Keep the shipping container until the unit is installed and fully operational. In
the unlikely event that the unit is defective, contact Canoga Perkins Customer Service for a return
authorization number (RMA) and instructions on return shipment. For details, see Appendix A.
2. On the UTP copper interface (9100-330), set SW1 for your system; see Figure 2 and Table 1.
SW1
Figure 2. SW1 on UTP Copper Interface
Table 1. SW1 Settings, UTP Copper Interface
Switch Name On Off
1-1 10 or 100 Mbps 100 Mbps 10 Mbps
1-2 FDX Full-duplex Half-duplex
1-3 AUT (Auto
negotiation) Manages the fastest common operating mode
between this module and its link partner Follow SW1-1 and 1-2
settings
1-4 LLF Enable Link Loss Forward (LLF) Disable LLF