CANOGA PERKINS 9135 SNMP Managed 10/100/1000 Ethernet Switch - Manual (Page 38)

EdgeAccess Universal Chassis System
Model 9135 10/100/1000 3-22
7. Start the download. The process sends the upgrade directly to the inactive Flash location.
8. When the TFTP client indicates the transfer is complete, close the TFTP program.
9. To activate the new software revision, reset the 9135, then return to the Description screen to
verify that the new Software Revision is listed as active and the old version remains in the
inactive Flash.
3.13 Update the Software Through FTP
To verify the software revision currently stored in the Flash memory and used by the 9135:
1. From the Main Menu, type
4
and press <Enter>. The Reports menu appears.
2. From the Reports Menu, type
1
and press <Enter>. The Description screen appears.
3. Record the version numbers for Software Revision Flash1 and Software Revision Flash2.
4. To check if a newer version of the software is available, access www.canoga.com. Click
Downloads and scroll to the 9135. The last digits of the filename indicate the version number; for
example, 9135GII0330.img indicates firmware version 3.30.
5. If the web site lists a newer version than is available on your 9135, use the FTP Client on your PC
to download the upgrade file and to the 9135. Start the FTP Client to begin the upgrade, then
enter data for the download:
Note: These are general steps for the FTP utility. For details, see the documentation for your FTP
Client.
6. On the 9135, access the IP Settings screen, select
5
, Enable Download, then select either FTP
only or TFPT and FTP.
7. Start the FTP Client and change to the directory were the upgrade is stored.
8. To start the download, enter
ftp xxx.xxx.x.xx
where xxx.xxx.x.xx is the IP address for the
9135.
9. At the prompt for the User, enter
supervisor
in lower case, then at the prompt for the
password, either enter the password for supervisor access or, if no password has been set, enter
password
. You must enter a password, even if no password is set.
Note: If the login fails, enter
quit
and restart the FTP client or enter
user
and repeat this step.
10. At the prompt, type
dir
and check the file names for the Active and Inactive software. These
are the versions in the active and inactive Flash memory.
11. At the prompt, enter
binary
to enable the file transfer format.
Note: To view the file transfer progress, type
hash
.
12. To start the transfer, type
put 9135GXXXX.IMG
where XXXX is the version number.