CANOGA PERKINS 9145 Network Interface Device - Manual (Page 22)

9145 Network Interface Device 3-2
Setting Up SNMP Network Management
Typically, the 9145 communicates with CanogaView or your Network Management
Platform in-band via the transported Ethernet Network.
Network Management Platform Set-up
Industry standard Management Information Bases (MIBs) are required on your Network
Management Platform in order to successfully communication with the 9145 using
SNMP. Before you start, check that these industry-standard MIBs are loaded:
• Standard
MIB
• Dot2sd.mib
• Etherlike.mib
• If.mib
• Bridge.mib
• Pbridge.mib
Additionally, Canoga Perkins Private MIBs are need on the Management Platform. The
Canoga Perkins Private MIBs are available on Canoga Perkins web site,
www.canoga.com . The MIBs are located in a password protected area of the Web Site.
If you do not yet have a Canoga Perkins Username and Password, please contact Tech
Support.
• Cp.mib: Supports all Canoga Perkins products
• Cpsysinf.mib: Supports SNMP access
• Cphost.mib: Supports Host Table and Host Access functions
• Cptraptb.mib: Supports the Trap Table
9145 Set-up
There are several TCP/IP and SNMP parameters that need configuration before
accessing the 9145 from CanogaView or your Management Platform. These
parameters include TCP/IP Address, Authorized Host list and privileges. These
parameters are initially using VT-100 Terminal on the RS-232 Serial Port. Please see
the System Configuration section for details on configuring these parameters.