CANOGA PERKINS 9145 Network Interface Device - Manual (Page 35)

9145 Network Interface Device 3-15
To upload a configuration file from the 9145 follow these steps:
1. Open a command prompt on your PC and type [ftp xxx.xxx.xxx.xxx] where the
x’s are is the IP address corresponding to the 9145’s management IP address and
press <enter>.
2. Type the user name and password and press <enter>
3. Set ftp to “binary” mode by typing [binary] on the prompt and press <enter>
4. Change directory to the CONFIG directory by typing [cd CONFIG] and press <enter>
Note: that the word “CONFIG” has to be capitalized.
5. Type [dir] on the prompt to view the contents of the directory and press <enter>