CANOGA PERKINS 9145 Network Interface Device - Manual (Page 62)

9145 Network Interface Device 3-42
• SNMPv3- Inform Notification
To configure SNMPv3-Inform notification, either type [a] value and press <Enter> or
press <Space> to cycle through the options for these parameters:
• Security Name: Enter the name of the user account at the destination. Up
to 10 characters
• Engine ID: Enter the SNMP Engine ID at the destination. 64 Hex
characters.
• Authentication Protocol: Notification authentication. Option are MD5, SHA, or
None.
• Authentication Password: The password that generates the authentication key for
the message when the authentication protocol is MD5
or SHA. 8 to 15 characters.
• Authentication Key: The authentication key for MD5 or SHA Authentication
Protocol. The key generates automatically from the
Authentication Password, but can be changed if the
destination uses a different Authentication Key generation
algorithm. 16 Hex characters for MD5 protocol or 20 Hex
characters for SHA protocol.
• Privacy Protocol: Set the protocol for encrypting the notification when MD5
or SHA is used. Options are DES or None.
• Privacy Password: If the Privacy Protocol is DES, enter the password that
generates the encryption key for the message. 8 to 15
characters.
• Privacy Key: Shows the that encrypts the message for DES Privacy
Protocol key. This key automatically generates from the
Privacy Password, but can be changed if the destination
uses a different Privacy Key generation algorithm. 16 Hex
characters.
• Security Level: No Auth/No Priv - No user authentication or message
encryption
Auth/No Priv - Authenticates by user name, no message
encryption
Auth/Priv - Authenticates by user name and message
encryption
• Retries: Number of times to resend the message if not
acknowledged. Range is 0 to 10
• Timeout in Seconds: Time to wait, in seconds, for an acknowledgement before
resending. Range is 1 to 30 seconds
3. To delete a destination, type [d] and press <Enter>. At the prompt, highlight the IP Address
for that Host you want to delete and press <Enter>. The host table appears again with your
changes.
4. To return to the Main Menu, press <Esc>.