CANOGA PERKINS 9145 Network Interface Device - Manual (Page 55)

9145 Network Interface Device 3-35
Configuring Host Access
The 9145’s SNMP Agent allows access by up to 24 Host IP addresses. Configuration and
editing the Host information Table is by the Host Access Table Menu. To access the Host
Access Table, follow these steps:
1. From the System Configuration Menu, type [ 1 ], "IP/SNMP Agent Configuration," and
press <Enter> Then type [ 3 ], "Host Table," and press <Enter>.
2. At the Host Access Table Menu, type [a] to add a host. At the prompt, enter the Host IP
Address and Subnet Mask, or type [e] to edit an existing Host.
Canoga Perkins Corp. Ethernet Network Interface Device 29-Nov-2006
Model 9145-5 V05.00 F96 9145 D 10:22:03
--------------------------------HOST ACCESS TABLE-------------------------------
Managing Host Telnet FTP SNMP SNMP V1/V2c Rd V1/V2c Wr V1/V2c
IP/Mask Bits Access Access Access Protocol Community Community Access
172.016.002.040/32 All All Write V1/V2c/V3 public private Superv
Select [(A)dd, (D)elete, (E)dit, (M)ore]:
------------------------------------Messages------------------------------------
Canoga Perkins Corp. Ethernet Termination Service Unit 05-Dec-2006
Model 9145-4 V05.00 F96 07:56:39
----------------------------------EDIT HOST ACCESS------------------------------
Managing Host IP : 172.16.2.40
IP Mask Size : 32
1. Telnet Access : Telnet and SSH
2. FTP Access : FTP and SFTP
3. SNMP Access : Write
4. SNMP Protocol : V1/V2c/V3
5. V1/V2c Read Community : public
6. V1/V2c Write Community : private
7. V1/V2c Access Level : Supervisor
Select [1-7]:
------------------------------------Messages------------------------------------