CANOGA PERKINS 9145 Network Interface Device - Manual (Page 30)

9145 Network Interface Device 3-10
Layer 2 Statistics
Displays current Layer two Statistics
RMON Group 1 Statistics
Short for Remote Monitoring Specification (RMON). This screen displays current
RMON statistics.
System Alarms
Displays current conditions for local and remote alarms
System Log
Displays all system events
Utilities
Set-up and display basic information. Below are the sub menus:
Set Date & Time
An accurate date and time in the 9145 assures accuracy for events listed in the
System Log and for traps and alarms sent to the system administrator. You can
choose either manual setting of the date and time or configure automatic updating of
the clock using SNTP. Method you use depends on the 9145’s access SNTP Server
and your need for accuracy.
Reset Configuration to Default
This allows you to set all parameters within the 9145 to be set to factory defaults.
Change Password
This option allows the current account running to change their password.
VT100 Baud Rate
This option changes the baud rate of the RS-232 Serial Port when configured for
VT100 terminal support.
Slip/PPP Baud Rate
This option changes the baud rate the RS-232 Serial Port when configured for SLIP
and PPP support
PING Generation
This is a network trouble-shooting tool used to determine if a destination is reachable
from the 9145.
Static ARP Table
The Static ARP table lets you set or change specific IP and MAC addresses
Dynamic ARP Table
The Dynamic ARP table lists currently assigned IP and MAC addresses for various
9145 ports.
License Manager
Displays additional features enabled in the 9145.