Panasonic AG-DP800HP - Manual (Page 13)

m
EE
EE
Lens Clamp Lever
Lens Mount (Bayonet type)
LENS Connector (12-pin)
AUTO W/B (WHITE/BLACK)
BAL Switch
AWB:
ABB:
VTR START/STOP Button
TALLY Lamp
CAMERA GENLOCK IN
Connector (BNC)
CAMERA VIDEO OUT
Connector (BNC)
SC Rough Adjustment
Switches
SC Fine Control
Horizontal Sync Phase
Control
After attaching the lens to the lens mount, tighten this lever to hold
the lens in place.
The lens is attached to this mount.
The connecting cable of the tens is connected to this connector. For
a detailed description of the lens to be used, refer to the Operating
Instructions accompanying the lens.
The white balance is adjusted automatically.
Setting the AWB Selector switch at the side to A or B and then
operating the AUTO W/B BAL switch enters the adjusted value into
memory A or B. Bear in mind that this operation will not be per­
formed when the selector switch has been set to PRE.
The black balance is adjusted automatically.
The value to which it has been adjusted is entered in an exclusive
memory. When it is released, the switch automatically returns to its
center position.
This is for starting or stopping the recording.
This lights while the image being shot by the camera is being re­
corded by the VTR. It lights and flashes in tandem with the TALLY
lamp inside the viewfinder.
To apply genlock to the camera recorder from an external unit,
connect the unit to this connector.
The camera’s encoder (composite signal) output is sent to this
connector.
These roughly adjust the subcarrier phase in the genlock mode.
This finely adjusts the subcarrier phase in the genlock mode.
This adjusts the horizontal sync phase in the genlock mode.
13