Turn on the ac adaptor’s power, Set the camera recorder’s power switch to on – Panasonic AG-DP800HP User Manual
Page 33
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connect the camera recorder’s external DC input socket to the DC
OUT connector on the AU-B110 AC adaptor.
Turn on the AC adaptor’s power.
Set the camera recorder’s power switch to ON.
Check the pin signals of the external DC input socket when an external power supply other than the AU-B110 AC
adaptor is to be used.
POWER
OFF SAVE ON
Pin No.
Signal
1
GND
2,3
—
4
H12 V
NOTES
•When both the battery pack and AC adaptor have been connected, the power from the AC adaptor has priority in terms of which
power is supplied to the camera recorder.
•When the AC adaptor is used, the low battery level warning may appear depending on the battery selection menu setting. In a
case like this, it is recommended that “Ni-Cd 12 V” be set on the menu as the battery selected.
•When using the AC adaptor, be absolutely sure to turn the unit’s POWER switch to ON only after turning on the AC adaptor’s
power. If this sequence is reversed, the AC adaptor’s output voltage will rise slowly with the result that the unit may not operate
properly.
33