Gain selector switch, Output selector switch – Panasonic AG-DP800HP User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
GAIN Selector Switch
When the camera screen is dark, change the position of this switch
to increase the gain and make the screen brighter.
0 dB; The switch is normally kept at this position.
HIGH: The gain of the camera video amplifier is increased to the value
(9 dB, 18 dB, 24 dB or super high gain) which has been preset
using the on-screen menu. (Increasing the gain results in an in-
crease in noise.)
AGC (Camera AGC function): The gain is automatically adjusted to the appropriate value between
0 dB and 18 dB depending on the brightness of the screen.
(If the lens iris is in the manual setting, it will be forcibly set to auto.)
The gain is set to 0 dB when the light is adequate, and if is in
creased automalicaly when the lens iris is close to being kept open
all the time and yet the amount of light is insufficient.
'The camera AGC will not function properly when a lens without an
automatic aperture function is used.
AWB Memory Selector
Switch
A orB; When the front panel AUTO W/B BAL switch is set to AWB, the
white balance is adjusted automatically, and the adjustment value
is automatically stored in the A or B memory.
PRE: The white balance is preset to the color temperature of 3200K (the
illuminance temperature of a halogen lamp). At this position, the
front panel AUTO W/B BAL switch does not function when it is set
to AWB.
OUTPUT Selector Switch
CAM:
BAR:
This selects either the video signals being shot by the camera or
the color bar signals.
The video signals shot by the camera are output.
The color bar signals are output.
8