Panasonic SC-AK90 - Manual (Page 10)

W)
C
.0
£
S
0
1
TUNER ¡BAND
/ X j ^ 03 OP
- n -1 r-1 ikoTki?
■ fO B 7 9 « '*’
B
I TwSan ^
JJ-I
l \» Ì,, / //«to
^----------------------------- -----------V ÉììD I
Cr;n7jURQ
r r - t r EMI
CinTesi
(r n B B. 0 -
-, ia GSD
(- I J n (-1 ri ^ ^
■i^r r-t1 BBB
J^J
^-1-1
-l-l-l
Preset channel
■
^
i ^ ^ 03
f- » J i-t i-t ri
r n BBB " “
Presetting radio broadcasts
• Up to 12 stations can each be set in the FM and AM bands automat­
ically.
• If broadcast frequencies are preset in the memory, you can easily
tune in any of these frequencies from the system or remote control
unit.
• You can also preset just those stations you like.
(See "Presetting only your favorite stations" below.)
[] Press TUNER BAND to select “FM” or “AM”.
The power will come on automatically.
Ever)^ time you press the button; "FM" *—* "AM".
Q Press TUNE MODE to select “MANUAL”.
Every time you press the button; "MANUAL" <—* "PRESET".
Q Press V or A until the display shows the fre­
quency from which you want to begin auto­
matic memory presetting.
Tips on tuning in radio stations
© Hold down either
v or
a
until the frequency numbers start
scrolling.
@ When nearing the desired frequency, press the button to
stop the scrolling and then fine tune the broadcast.
FI Press and hold down MEMORY/SET until the
frequency begins to change.
This will start presetting automatically. When finished, the
radio will tune in last station memorized.
If auto presetting is not possible because radio signals are weak
or for some other reason, do the following.
Presetting only your favorite stations
Preset the stations one at a time.
1. Perform above steps 1 and 2. Then, select a station with v and a ,
and press MEMORY/SET, "PRGM" will flash on the display.
2, While 'TRGM" is flashing, select a preset channel with v or
a ,
and press MEMORY/SET again. "PRGM" will go out and the
station will be stored in memory.
FM allocation setting
The FM frequency step is set to 0.2 MHz at the time of shipment.
By adjusting the allocation as shown below, you can enable the
system to receive FM broadcasts allocated in 0.1 MHz steps.
1. Press and hold TUNER BAND for approximately 5 seconds.
The frequency display will be returned to the minimum frequency
of the FM band and the display will begin to flash.
Keep holding for approximately 5 more seconds.
2. When the display stops flashing and indicates a different fre­
quency number (the frequency step is changed to 0.1 MHz.), re­
lease TUNER BAND.
To return to the original frequency, repeat steps 1 to 2 above,
nwa
After changing the "allocation" setting, the frequencies you pre­
viously preset in the memory will be cleared.
Memory retention
Your preset frequencies are retained in memory for about 2 weeks
while the system is unplugged.