Panasonic SC-AK90 - Manual (Page 12)

Listening to CDs
W)
C
.0
s
4)
8
Setting/Removing CDs
You can set CDs in the rack and remove them too, while playing CDs.
How to set CDs
1. Open the rack panel.
Uffig
Except when setting or removing CDs, keep hands out of the changer
while open. You could injure yourself if somehow entangled in the
internal mechanism.
2. Slide the loader carriage to the slot you want.
The loader carriage has a LCXHK position (when the lever is
down) and a RELEASE position (when the lever is up). When you
slide the loader carriage to select the slot you want, make sure it
is in the RELEASE position (when the lever is up).
You can read the numbers between the prongs as shown below.
Slot No. 0 (SINGLE) is reserved for single CD play (p. 15).
3. 0 Lower the lever on the loader carriage and set
the CD in the groove with the label facing to
the right.
© Raise the lever.
Label side
c>
4. Close the rack panel gently.
You will hear a catching sound when the rack panel closes.
Press on
center piece.
How to remove CDs
1. Open the rack panel.
2. Slide the loader carriage to the slot you want.
Do not slide the loader carriage when the lever is down.
3. Lower the end of the lever and then remove CDs.
o
How to know what CD is in what slot
This system comes with a notebook-like binder (liner notes orga­
nizer) in which you can keep your CD liners. There are also adhesive
numbers for indicating slot numbers in the binder. This is a conve­
nient way to keep track of what CD is in what slot.
Adhesive Pocket
Put two liners back-to-back inside each pocket, as shown above.
Do not put CD cases in the binder.
To prevent damage
Always observe the following points.
•Never load more than one CD in any given slot.
• Do not use 3" (8 cm) CDs fitted with expander rings.
• Do not put anything other than CDs in the changer.
• Do not set a CD in the slot of the CD being played (slot flashes).
•Sometimes the rack panel cannot be opened while a CD is playing.
It is a question of time. In such case, wait until you can open it.
• Do not open tha rack panel while the changer is changing CDs.
• Do not use cleaning CDs or CDs which are badly warped or
cracked.
•Set the system on a flat, level surface.
Do not set it on top of magazines, inclined surfaces, etc.
• Always unload all CDs before moving the system,
• Do not use CDs with poorly attached labels or stickers.
Adhesive protruding from underneath stickers or left over from
peeled off stickers can cause the system to malfunction,
• Do not use irregular shape CDs (heart-shape, octagonal, etc,).