Panasonic SC-AK90 - Manual (Page 33)

Using the sleep timer
To switch the timer OFF
Press © REC/® PLAY and check "® REC" goes out.
If you set the timer wrongly
Press © REC/® PLAY so that "® REC" goes out. Then, repeat the
procedure from step 1,
To check settings
Press CLOCK/TIMER to select "© REC".
Two seconds later, the display will change in the following order.
® Recording start time
@ Recording over time
@ Recording source
You can check settings even when the system is OFF.
To enjoy the desired source after the timer setting is
completed.
Even if you change the music source, the timer recording will start
with the preset condition,
1. Following step 6 on page 32, turn ON the power and start playing
the desired source.
2, Press POWER to standby mode after you have enjoyed listening to
your desired source, and confirm a tape is inserted in deck 2.
Turning the timer ON/OFF
As long as "© REC" is displayed, the record timer will come ON
everyday as set
You can turn the timer ON/OFF by pressing "© REC/® PLAY"
while the system is OFF.
Remember that when "® REC" is displayed, the timer is ON. When
not displayed, the timer is OFF,
•If the power is ON, the timer will not function. The system must be
in the standby mode.
•If you switch the power to the standby mode while the record timer
is functioning, the OFF time setting will not be activated.
• If ALfX is selected as the source, when the timer comes ON, the
system will turn ON, will engage "AUX" as the source and will start
recording. If you want to record from a connected component, set
the component's timer to the same time. (Refer to your equipment's
operating instructions.)
by remote control only
Preparations
Switch on the power.
While enjoying the desired source:
Press SLEEP to select the desired time. Q
Every time you press the button;
30-> 60-> 90--r 120-> OFF-
C _]
The figure shows how to set the system to standby mode after
30 minutes.
The system is turned off after the set time has elapsed.
To cancel the sleep timer
Press SLEEP to select "OFF".
To confirm the remaining time
(only while power is ON)
Press SLEEP.
To change the time remaining during operation
Press SLEEP to show the remaining time, and then press SLEEP to
select the desired time.
IJBIBI
The sleep timer turns OFF automatically the moment you attempt to
record a CD using CD MANAGER function.
W)
C
&
I
k
o
E