Panasonic SC-AK90 - Manual (Page 21)

To fast-forward or rewind the tape
Press or ►►/►w in the stop mode.
Tape direction To rewind To fast-forward
To find the beginning of a program
(TPS: Tape Program Sensor)
Press or ►►/►►! during play.
Tape
direction To play the current tune
from the beginning
To play the next tune
from the beginning
UBig
The TPS function searches for silent parts of about 4 seconds in length
which are normally found between tunes. As a result, it may not
function properly in the following cases.
• With short silent parts
• When noise occurs between tunes
• With silent parts found within tunes
Before recording fOeck 2 only)
Type of tape which can be recorded correctly
The system automatically identifies the type of tape.
NORMAL POSITION/TYPE I 0
HIGH POSITION/TYPE II 0
METAL POSITION/TYPEIV X
This system cannot correctly make a recording or erasing, if metal
position tapes are used.
To record from the beginning of the tape
You cannot record on the leader part of the tape. Before recording,
wind the tape past the leader to a point where recording can start
immediately.
Recording part
Leader tape
(no recording can be made)
How volume, sound quolity/field, super
woofer and V. BASS effect recording
The tape you are recording is not affected whatsoever by changes
in volume, sound quality/field, super woofer (SC-AK90/SC-AK91}
or V, BASS (SC-AK70/SC-AK71).
• In recording, sound quality/field are set automatically to “FLAT".
• You can change volume, super woofer and V. BASS effect for the
playback sound.
To erase a recorded sound
1. Press TAPE DECK 1/2.
2. Insert the recorded tape into deck 2.
3. Press REV MODE to select reverse mode.
4. Press •REC/STOP.
•
I
• You cannot open the deck 1 while recording,
• You cannot fast-forward or rewind one deck while recording with
the other.
tn
C
•I
s
4)
&
D>
C
t
o
u
&