Panasonic SC-AK90 - Manual (Page 22)

W|
C
z
Q)
&
S
S
0)
OÉ
DECK 2 f ^
-IJJ
-1-1 J-1^
Tape direction
4
(3^
JRPE
11 fSÓ
'—ir'
^ 11^
1 sO
TRPE fUT
□ RECSTOP
J-lil
-l-l-l JJ-f
-l-J-l
' i • CS?JL5?)
_ J-l r-i J
rn GB/ " “
! (nn SP S
W
\ ™ / / / j
( G r / SPP!
Recording from radio broadcasts
n Press DECK 2 ^ OPEN, and then insert the
tape.
Close the holder by hand.
Tape direction is automatically set to "► ".
Q Press REV MODE to select the reverse mode.
Every time you press the button;
ti___nL_lij^
X: One side is recorded, then recording stops auto­
matically.
Both sides (front side^ reverse side) are recorded,
then recording stops automatically.
ft\ Select a radio station. Perform steps 1 through
3 on page 11.
FI Press • REC/STOP to start recording.
If you selected in step 2, the direction will automatically
change to when recording starts.
To stop recording
Press 9 REC/STOP again.
Recording can also be stopped by pressing ■ .
To start recording on reverse side
Load a tape and change the tape direction as explained here below.
1. Press TAPE DECK 1/2 and select tape deck 2.
2. Press M and immediately thereafter ■ . The tape direction will be
shown as
To record from a specific point on a tape
Before recording, advance the tape to the point from where you want
to start recording.
To cut an unnecessary part whiie recording
1. Press • REC/STOP when hearing an unnecessary part. The cas­
sette deck will go into the stop mode.
2. Press # REC/STOP to resume recording. Recording will continue
in the same direction as before.
iTWTjj
When recording an AM broadcast, volume is momentarily inter­
rupted when you start and stop the recording.
To reduce the noise while recording an AM
broadcast (Beat proof function) El
Press FM MODE/BP while recording.
Each time you press the button, BP 1 and BP 2 will be displayed
alternately.
Select the position where there is less noise.