Panasonic PANAFAX UF-321 - Manual (Page 55)

Receiving Documents
Reception Modes
You can select one of the four modes as shown below.
Conditions Suggested Reception Mode Settings
You normally receive
only voice calls.
Telephone Mode
(Attended)
You can answer the incoming call via the handset.
If you receive a fax calling signal, simply press
START to receive manually, (see page 54)
Ф Fax Parameter No. 15 set
to 1 : Tel
^ RCV MODE
a
n
Lamp : OFF
You receive both voice
and fax calls.
Fax / Tel Auto Switching Mode (see Note 2)
(Attended)
Unit will answer the incoming call then
distinguishes whether it is voice or fax call. If it is
a fax call, the unit will receive automatically, if it is
a voice call, the unit will signal (rings) through the
speaker for your attention, (see page 55)
(D Fax Parameter No. 15 set
to 2 : Fax / Tel SW,
/Яч RCV MODE
Lamp : OFF
You normally receive
fax calls only.
Fax Mode
(Unattended)
Unit will receive the document automatically. All
incoming calls (including a voice call) are
answered by the fax machine, (see page 56)
Ф Fax Parameter No. 16 set
to 1 : Fax
^ RCV MODE
Launp : ON
You receive both voice
and fax calls. And a
Telephone Answering
Machine (TAM) is
connected.
TAM interface Mode (see Note 2)
(Unattended)
The TAM answers the Incoming call. During that
time, the unit also monitors whether it is a voice
call, the TAM continue to operate. If it is a fax call,
the unit wiii automatically switch the line to fax
and begin receiving document, (see page 58)
Ф Fax Parameter No. 16 set
to 1 : TAM 1 / F.
(2)
RCV MODE
Lamp : ON
Ш
Note: 1. Depending on the model of the Telephone Answering Machine (TAM) that is connected, some of the
feature may not be compatible with the your machine operating in the TAM Interface mode.
2. For some countries, this mode is not available because of the country’s regulation and specification.
53