If you have any of these problems, Troubleshooting – Panasonic PANAFAX UF-321 User Manual
Page 83
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Troubleshooting
If You Have Any of These Problems
Mode
Symptom
Action
Page
During Installation
Problem
The display is blinking
Battery discharged completely. This may happen at first
installation. After setting the clock, the blinking will stop.
—
During Transmission
Probiems
Document doesn't
feed/multiple feed
1. Check that your document is free of staples and paper
clips, and that it is not greasy or torn.
2. Check that your document is the right type to send through
a fax machine by consulting the list on "Documents You
Cannot Send". If your document has the characteristics
listed, make a photocopy of your document and send the
copy instead.
3. Check that the document is loaded properly.
4. Adjust the ADF Pressure Plate.
37
38
92
Document jam
The information code 031 will appear on the display if the
document becomes jammed.
87
Does not stamp
1. Check if Stamp LED is lit.
2. Check Fax parameter No. 04 and No. 28 settings.
40
34,35
Stamp too light
Replace stamp or refill ink.
93
Transmission Copy
Quality Problems
Vertical lines on the
transmitted document
Check own copy quality. If copy is OK, your machine has no
problem, report to receiving party that they have a problem. If
copy is NG, clean the Document Scanning Area.
91
Transmitted document
is blank
1. Make sure the document is set face down.
2. Check own copy quality. If copy is OK, your machine has
no problem, report to receiving party that they have a
problem.
No recording paper
The information code 010 will appear on the display if the paper
runs out.
17
Recording paper jam
The information code 001,002 or 016 will appear on the display
if the paper gets jammed.
86
During Reception
Problems
Recording paper
doesn't advance into
machine
Make sure that there is paper in the Paper Supply Tray.
Follow instructions for loading paper.
17
Recording paper
doesn’t eject after
printing
Check to see if the recording paper is jammed inside of the
machine.
86
Document auto
reduction doesn't work
Check Print Reduction settings.
59
Out of ink
The information code 015 will appear on the display if the Print
Cartridge runs out of ink.
15
81