Panasonic CF-E1M - Manual (Page 13)

Set the stand for the keyboard
Stand
When the ‘TILT UP” button is pressed, the stand can be
rotated and the keyboard can be raised.
^NOTE>
When the keyboard is not in use
(T) Hold both ends of the keyboard and ro­
tate the stand to its original position.
@ Slide the keyboard under the computer.
Power Indicator
Turn your computer on
Press the power switch and hold it for approximately one second until the power indicator
(O) turns on before releasing it.
r
After confirming that the power indicator has turned on, do not touch the power switch
until Windows setup has started.
-J
T note )-
When the display becomes black (i.e., goes OFF) during operation
The power management function is set at the factory, and therefore, if the computer
is not used for about 15 minutes, it automatically darkens the display of the screen
and controls the consumption of power. If either a key is pressed or the mouse is
moved, the original screen will reappear. Do not leave your computer during the
setup procedure to prevent accidents such as another person pulling out the AC
cord.
If you leave the computer, the power to the LCD may be turned off while Windows
is setting up or even when an application software is being installed. In this case,
because it is conceivable that a selection dialog box will be shown, do not press the
( Enter ] key to attempt to resume from this condition as doing so may trigger a
selection, but instead, press a key unrelated to the direct triggering of a selection,
like theC Ctrl )kev.
13