Panasonic CF-E1M - Manual (Page 55)

Disk Operations
Cannot read/write to a
floppy disk • Has the floppy disk drive been correctly connected?
• Has the floppy disk been correctly formatted?
• Your floppy disk content may be corrupted.
• Is the floppy disk write-protected?
Unable to read/write to the
hard disk • Your drive or file may not have been properly set.
• Check to see if the hard disk is full. If it is full, delete unnecessary files.
• Your hard disk content may be corrupted. Contact Panasonic at 1 -800-272-7033.
A CD or DVD cannot be
ejected Is the computer ON? To eject a disc when the
computer is OFF, insert the eject pin (included)
intO'the recessed manual disc eject button and
pull out the tray.
Recessed Manual Disc Eject Button
DVD-ROM indicator lamp
(@) does not light
Is the disc properly set on the tray?
A CD or DVD disc cannot
he played or read
Is the disc deformed? Or, are there marks or dirt on the disc?
If there is dirt on the disc, clean the disc ( q = page 24).
A blue background appears
on the screen with the
MPEG image
Did you open the DVD-ROM drive or remove the disc while it was operating?
Re-insert the disc and close the DVD-ROM drive. Press C Enter ) .
The vibration of the DVD-
ROM drive is large
Are you using a deformed disc or a labeled disc?
The DVD-ROM drive can­
not be used in the MS-DOS
mode
When using the DVD-ROM drive in the MS-DOS inode, add the necessary driver with
the following procedure.
1 Select [Start] - [Shut Down],
2 Select [Restart in MS-DOS mode] and click [OK],
3 Open the “CONFIG.SYS” file for editing by issuing the following commands:
cd \ (EnteO
edit config.sys C Enter)
4 Move the cursor to the line containing “OAKCDROM.SYS” and delete the characters
“rem” at the beginning of the line. (Deleting “rem” causes the item to become valid.)
DEVICEHIGH-C:\WINDOWS\COMMAND\OAICCDROM.SYS /D:MSCD000
(If this line is missing, add it.) _____ __________________
5
Press
CHD+CEi
, then
CE)
to save the file. Then press
CSD+CD
, then
CD
to exit
the Edit program.
6 Follow the same steps to edit the “AUTOEXEC.BAT” file,
edit autoexec.bat C Enter)
7
Move the cursor to the line containing “MSCDEX.EXE” and delete the characters "rem"
at the beginning of the line. (Deleting “rem” causes the item to become valid.)
LOADHIGH C:\WINDOWS\COMMANDVMSCDEX.EXE /DiMSCDOOO /L:L
(If this line is missing, add it.) _____ __________________
6
Press
C M ) +CD
, then
CD
to save the file. Then press
C M ) + C f )
, then
CD
to exit
the Edit program. ______ __________ _________
9 Restart the computer by pressing
C M )
+ rctrD + fpin.
Communication
Unable to connect to the
telephone line
• Confirm that the connection between the modem and the telephone line is correct.
• Confirm that the correct type of telephone line has been set.
• Are the communication settings correct?
# Network
Unable to connect to a net­
work
• When using the computer as a network computer, additional settings may need to be set
depending on the usage conditions. Ask your system administrator or the person in eharge
of the network.
• The computer must be restarted if hibernation mode is entered.
55