Panasonic CF-E1M - Manual (Page 23)

Making Settings In the Control Panel
7
Select [Start] - [Settings] - [Control Panel]
2
Select [YAMAHA DS-XG Audio Config]
Setting of digital output mode
I
^ Y4MAHA DS-XG Audio CortMg j]
[^Diflilal Outpii I DiiedSourJ |
AhoU^ jj Simthatge) | Echo | Dipiljrintiut
Y«n^DS-XC
Vetsioo
Cot^iohi (c)Yi
Al lights tesefvid
Cor^ig
1Zm,201S
'/JMAHA Colpoiation
]t^
- Set output from the headphones or speaker,
-Set output from an MS-DOS application.
-Display of digital input
Set the echo level during microphone input.
Settings of the echo level and tone level during MIDI playback.
NOTE>
Refer to the instructions on the settings by clicking the item after clicking the [i^j
button in the display.
After setting each item, click [OK]
r
About digital output
• You must adjust the sound level on a peripheral device ( q * page 32) when con­
necting to the optical digital audio output on the computer.
• If a check mark is added to the [Mute All] in [YAMAHA DS-XG Audio Mixer] -
[Volume Control], the digital audio output will also be muted.
If no sound is audible from the digital audio output even if the check mark is
removed from [Mute All], increase the [Volume Control] level.
(Adjust the sound volume on the peripheral device.)
[Dolby Digitall playback of a DVD video disc
• When a peripheral device is not compatible with [Dolby Digital] output, the disc
will not be played correctly. In addition, there are cases in which large sounds arc
output at the same time as the playback of the sound source. Reduce the sound
volume of the peripheral device.
• When no sound is output from the optical digital audio output terminal, click the
[Digital Output] tab, then confirm that 0 is not on the left side of [OFF] or [ON
(Direct)]. (Confirm the sound level of the peripheral device beforehand.)
• Confirm that the sound setting in the application software is correct.
23