Panasonic KX-P6500 - Manual (Page 16)

Setup
Notes:
• If the paper guides are not adjusted properly, your printout may be skewed.
• Do not load paper of different types or thickness in the paper tray at one time; this may cause a paper jam.
• When you want to add more paper to the paper tray, you must first remove the remaining paper from the tray
and then place the entire stack of paper into the tray.
• Make sure you load the paper with the print side up. Most paper has instructions recommending the side to
be printed first. When using 60 g/m^ (16 lbs.) paper, always load the paper with the “non-curl side” up rather
than following instructions on the paper package.
• For more detailed information on paper, refer to “Paper Specifications” ( P. 61).
• Do not allow more than 50 sheets [75 g/m^ (20 ibs.)] to accumulate in the output tray. This may cause a paper
jam.
Loading Envelopes (Labels, Transparencies)
You may load either 30 sheets of labels, 30 transparencies, or up to 10 envelopes in the paper tray. You can use
Business Commercial #10, Monarch, International DL and International C5 envelopes. For more detailed information
on Envelopes, refer to “Envelope Specifications” ( irg= P. 63).
Notes:
• Make sure that all seams are properly sealed before loading envelopes.
• The envelopes must be loaded with the shorter side first to avoid a paper jam.
• When installing envelopes, the flaps should be face down.
•To print lengthwise on the envelope (along the longer side), set the printing mode to landscape
( cs=P. 34,41).
Perform steps 1 and 2 on page 15.
2 Adjust the paper guides to the approximate
width of your enveiope.
Piace the en veiopes in the paper tray with the
sides to be printed facing up. Position them
between the paper guides, and adjust the
guides untii you feel resistance.
Verify that your envelope matches the paper
size set through the GDi Mode ( P. 34) or
PCL Mode ( P. 41) and software applica­
tion for proper print aiignment.
16